Problem 1. None of the articles, photos, videos, show the engine compartment of a Z4. You have about 4” of space between the vanos unit and the steel bulkhead in front of the radiator. Having removed the six 6mm nuts and one larger nut that bolt the vanos to the block you have to pull it back off the studs, mine did not clear the two longer
2)do the same on the passengerside. 3)go to the rear, look at the center where the two bars come together and bolts on. Jack from there to a position and place jackstands under the factory jack location on the sides. 1)get the car in the air. all 4 tires off, and in somewhat of a leveled position. 2)notice where you jacked up the car in the Cincinnati, OH. Tulsa, OK. Oklahoma City, OK. Boston, MA. Philadelphia, PA. A full list of recommended 2004 BMW Z4 regular maintenance including pricing. Find local service centers, car repair Below is step one: move the cloth out of the way so you can see above and below the tray. This shows where one of the retaining rivets was located. Remove this, the torx, and there is a 10mm (approx) bolt at the back where part #5 goes. You will be able to access this better once the tray has been removed. 945 posts · Joined 2012. #4 · Jul 21, 2013. Castrol has a new full synthetic that's states on the front it's for BMW, Volkswagen and Mercedes 5-40 and on the back it states it meets LL-01 specs. I found this right after doing an oil change. My oil consumption is about I litre in about 1000-12000 Km's or less. I intend to switch next oil
Add To Wishlist. MSRP Price: 33.32. BW Part #: 51617199687. Brand: Genuine BMW. (In Stock) Description. Customer Reviews. This is the plastic oil drain access panel installed on the front aluminum reinforcement/undertray on E46 and and first generation Z4 models (which is the E85 chassis). This flap was installed at the factory, but careless or
7 liters 5W-30 BMW Z4 motor oil, oil filter, and hardware for 2.5L 24V E85 applications. Oil carries OEM approval for BMW Longlife-01 oil standard.
Looked around on how to reset the change and found how to. - Iginition OFF (POS 0) - Press and Hold the trip odometer button while turning key to Position 1 (Accessory) - Keep the button depressed (about 5 seconds) until you see 'Oil Service' or 'Inspection' with 'Reset' or 'Re' in the display. - Press the button again and the display will
1. Ignition in the off position. 2. Push and hold the trip reset button while turning the key to position "1" or Accessory. 3. Continue pushing the button for 5 additional seconds until the display changes and "inspection" or "oil service" appears. 4.

A quick DIY video on how to change differential oil on an E85/E86 Z4 BMW.BimmerZen assumes no liability for property damage or injury incurred as a result of

Next, start or attempt to start engine. Fuel pressure should be: S54 6-cylinder: 5.0 bar +/- 0.2 (72.5 psi +/- 3). NG6 engine should be similar pressure. Figure 4 The fuel pump module (EKPS) in BMW Z4 models is located in the right side of trunk, behind the battery hidden by carpet trim (red arrow). .
  • 5wkb2nt279.pages.dev/8
  • 5wkb2nt279.pages.dev/362
  • 5wkb2nt279.pages.dev/461
  • 5wkb2nt279.pages.dev/322
  • 5wkb2nt279.pages.dev/257
  • 5wkb2nt279.pages.dev/345
  • 5wkb2nt279.pages.dev/284
  • 5wkb2nt279.pages.dev/261

    • bmw z4 e85 oil change